Piseth

Objectives of the internship

Implement WSN(Wireless Sensor Network) with different use cases and security mechanism/protocol. Analyze and Evaluate.

alt Test Alt

Hardware

SmartRF06 EB (Evaluation Board)

• Power supply (Battery, USB pc or 5V external source, external source(3.6v))
• Switches, Pin connector on Board
• How to reset , go to bootloader (boodloader sequence check)
• Ports (to CC2538, to Sensortag)
• UART over XDS100v3

CC2538 EM

• Power supply (throught EB or 3.3v usb)
• Ports connection
• What can CC2538 be used to

Compile Firmware

• Make command

Flash Firmware

• CC2538-bsl
• Uniflash (Linux)**
• SmartRF Flash Programmer**
• Restore to Default firmware (Factory Firmware)

//**Note: Could be moved to Tools sections

CC2650 Sensortag

• What it can be used
• Power Supply (Through Sensortag DevPack, Battery)
• Default function of buttons (Disconnect, Reset to factory)

Compile Firmware

• Make command (Could point to contiki project structure section)

Flash Firmware

• Flash via OAD
• Flash Default Factory Firmware
• Uniflash (Linux)**
• SmartRF Flash Programmer**

//**Note: Could be moved to Tools sections

CC2531 Dongle

• What it can be used. (Sniffer, Mote, Slip-radio)

Pending to be Documented

• flash usb dongle
• access 6lbr embedded webserver from outside

Glossary

• RDC:
• ContikiMac:
• NullRDC:
• slip-radio:
• PANID: