TI IOT: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 22: | Line 22: | ||
On LinuxMint 17.3, I had to do the following: | On LinuxMint 17.3, I had to do the following: | ||
* Install gcc-arm-none-eabi and libnewlib-arm-none-eabi (this allows to compile the contiki code) | * Install gcc-arm-none-eabi and libnewlib-arm-none-eabi (this allows to compile the contiki code) | ||
* if system complains about "Could not find the cc2538-bsl script", | |||
Revision as of 12:03, 17 February 2016
The idea is to build a network of sensortags communicating over IPv6 (6LoWPAN).
TI Sensortags (CC2650SDK) will be used a nodes TI CC2538 will be configured as a 802.15.4 sniffer
Creating a 802.15.4 sniffer
- you need firmware that could act as a sniffer run on that mote (cc2538): the firmware, you could find on example on contiki folder ($CONTIKI_HOME/examples/cc2538dk/sniffer)
- need software what forward the packet from sniffer to wireshark (available here)
- setup wireshark to read those packet
To build a firmware, one need to install the proper toolchain first. Instructions are available here
Flashing the CC2538
The goal is to create a new firmware and flash it to the cc2538DK
To create the new firmware, let's use a Contiki example (examples/cc2538dk/cc2538-demo.c)
Instructions are available here
On LinuxMint 17.3, I had to do the following:
- Install gcc-arm-none-eabi and libnewlib-arm-none-eabi (this allows to compile the contiki code)
- if system complains about "Could not find the cc2538-bsl script",